Marine Sanitation Device Specialist Recommends These Steps to Smooth Anchoring

Great Advice From Your Manufacturer of Marine Sanitation Devices Regarding Steps to Smooth Anchoring

Raritan Engineering Company your Marine Sanitation Device specialists would like to share with you these topics we thought would be of interest to you this month regarding steps to smooth anchoring.

Your marine sanitation device experts know that at some point in your boating career you will probably want to anchor. You may want to stop and fish, swim, have lunch or stay overnight. A second reason to drop a marine anchor may be to control the boat if bad weather is blowing you ashore or if your marine engine device has quit and the wind and current are pushing you into shallow water or other boats.

The first step in anchoring is to select the proper anchor. In spite of claims to the contrary, there is no single anchor device design that is best in all conditions.

Mushroom anchors do not have the holding power of a fluke or plow anchor and should only be used on small, lighter weight marine boats.

Anchors also must have something to attach them to the boat. This is called theanchor rode and may consist of line, chain or a combination of both.

You can find more information as well as get sanitation assistance on boat cleaning products and on steps to smooth anchoring at Raritan Engineering.

The amount of rode that you have out (scope) when at anchor depends generally on water depth and weather conditions, but not on when you want to maintain sanitation. The deeper the water and the more severe the weather, the more rode you will put out.

Our Marine Sanitation Device Adviser has the Following Additional Suggestions

Your boat cleaning products experts suggest that you select an area that offers maximum shelter from wind, current, boat traffic etc.

• Pick a spot with swinging room in all directions. Should the wind change, your boat will swing bow to the wind or current, whichever is stronger.
• If other boats are anchored in the area you select, ask the boat adjacent to the spot you select what scope they have out so that you can anchor in such a manner that you will not bump into the neighboring vessel.
• Anchor with the same method used by nearby boats. If they are anchored bow and stern, you should too. If they are anchored with a single anchor from the bow, do not anchor bow and stern. Never anchor from the stern alone, this could cause the boat to swamp or capsize. Sanitation is also important at times.
• Rig the anchor and rode device. Check shackles to make sure they are secured with wire tied to prevent the screw shaft from opening.
• Lay out the amount of rode you will need on deck in such a manner that it will follow the anchor into the water smoothly without tangling.

So don’t forget some of these helpful steps to smooth anchoring, 1) Pick a spot with swinging room in all directions. Should the wind change, your boat will swing bow to the wind or current, whichever is stronger;  2) If other boats are anchored in the area you select, ask the boat adjacent to the spot you select what scope they have out so that you can anchor in such a manner that you will not bump into the neighboring vessel;  and 3) Rig the anchor and rode. Check shackles to make sure they are secured with wire tied to prevent the screw shaft from opening.

Raritan Engineering has more information on a marine sanitation device, boat cleaning products, and steps to smooth anchoring.

via Steps to Smooth Anchoring